This compact LED area light is ideal for illuminating footpaths, driveways, small private streets, small private car parks, yards, open areas etc. Supplied with a choice of 3, 4, 5, or 6 metre column. Five different models to chose from. Prices from £699.99.
This self contained LED raea light is supplied with a galvanised steel 3, 4, 5 or 6 metre tubular column and is available with a choice of five different luminaires. We offer five different versions with the 5W version providing up to 550 Lumens, the 15W version providing up to 1950 Lumens, the 20W version providing up to 2600 Lumens, the 30W version providing up to 3900 Lumens and the 40W version providing up to 5200 Lumens. The body of the luminaire comprises of a discrete solar panel installed on the top of the fitting, with a lithium battery installed inside, and a cluster of SMD/LED's on the under-side of the unit. Also on the under-side of the fitting is a PIR motion sensor. When it detects activity near-by, the light switches to full brightness mode and when the area is free of activity it will revert back to its ambient mode at approximately 1/3rd power. The light may be a good choice for windy locations based on is compact design. A choice of root moun tor flange mount columns are available with different heights. This light fitting can be used at sites where several PIR activations ocurr each night where the LED power is at maximum (100%) brightness. Otherwise, when there is not activity within the PIR detection area, the LED power remains at 33% brightness. This light fitting is not designed for continuous activations or dozens of activations that extend the maximum brightness for prolonged periods. Colour of product is grey. Colour of light output is white.
For small private streets, small private car parks and general security lighting around commercial buildings, yards, storage areas etc. where there is a need for a solar powered solution. For customers seeking a fast, efficient, convenient solution to area lighting.
Weather rating is I.P. 65
Ideal operating temperature charging range is 0 deg C. to +60 deg C.
Ideal operating temperature discharging range is -20 deg C. to +60 deg C.
Ideal storage temperature range is 0 deg C. to +45 deg C.
A passive infra-red (PIR) motion sensor is built into the luminaire on all models.
Motion sensor detection range (at ground level) is up to 6 metres (20') forward and with a 90 degree detection spread, up to 4 metres (13') left/right.
The detection range will vary depending upon a few factors including fixture mounting height, local ambient temperature etc.
All SMD/LED's have a color temperature of 6000-6500k.
The 5W model is fitted with multiple SMD/LEDs at 5w power and provides 550 Lumens at full brightness and 180 Lumens in ambient mode.
That is equal to approximately 120 watts of incandescent lighting.
The 15W model is fitted with multiple SMD/LEDs at 15w power and provides 1950 Lumens at full brightness and 650 Lumens in ambient mode.
That is equal to approximately 250 watts of incandescent lighting.
The 20W model is fitted with multiple SMD/LEDs at 20w power and provides 2600 Lumens at full brightness and 900 Lumens in ambient mode.
That is equal to approximately 300 watts of incandescent lighting.
The 30W model is fitted with multiple SMD/LEDs at 30w power and provides 3900 Lumens at full brightness and 1300 Lumens in ambient mode.
That is equal to approximately 400 watts of incandescent lighting.
The 40W model is fitted with multiple SMD/LEDs at 40w power and provides 5200 Lumens at full brightness and 1700 Lumens in ambient mode.
That is equal to approximately 500 watts of incandescent lighting.
The 5W model is approx. 33cm x 24cm x 5cm (13" x 9.5" x 2") LxWxD.
The 15W model is approx. 70cm x 36cm x 5cm (27.5" x 14" x 2") LxWxD.
The 40W model is approx. 115cm x 13cm x 5cm (45" x 13" x 2") LxWxD.
The 5W model is ideal for lighting up an area approximately 6m x 6m (20' x 20').
The 15W model is ideal for lighting up an area approximately 15m x 15m (50' x 50').
The 20W model is ideal for lighting up an area approximately 18m x 18m (60' x 60').
The 30W model is ideal for lighting up an area approximately 21m x 21m (70' x 70').
The 40W model is ideal for lighting up an area approximately 25m x 25m (80' x 80').
Integral high capacity Lithium battery pack pre-installed.
The system has built-in charge control regulation with over-charge and discharge protection.
Choice of 3m, 4m, 5m or 6 Metre column.
Column diameter is 76mm.
Column type is galvanised steel, root mount (direct burial)
The 3 and 4 Metre root mount column has approx. 75cm for burial.
The 5 and 6 Metre root mount column has approx. 100cm for burial.
Heavier duty columns are available with 89mm or 114mm diameter.
Flange mount columns for surface type installations (complete with anchor kit and template) are available at extra cost.
Painted or powder coating coloured finishes are also available at extra cost.
Alternative column heights are available by special order.
The 20' pole is made of galvanized steel and supplied with a satin gray finish.
The 10' (3 meter) pole is approximately 9.5' (285cm) high and has a welded base plate of approximately 1/3" (8mm) thick and approximately 10" x 10" (25cm x 25cm) square.
The 15' (4.5 meter) pole is approximately 14' 9" (435cm) high and has a welded base plate of approximately 1/3" (8mm) thick and approximately 10" x 10" (25cm x 25cm) square.
The 10' and 15' pole base has four pre-drilled elongated holes 3/4" wide.
The 10' and 15' pole is approximately 3" (76mm) diameter (O.D.) at the top and approximately 4.5" (115mm) diameter at the base.
The 10' and 15' poles are supplied with a rebar/anchor kit is included for installation into wet concrete with nuts, bolts and washers.
The 10' and 15' poles can be fixed to an existing concrete pad using suitable expanding anchor bolts (not included).
The 20' pole has a square flat base (flat plate) with pre-drilled holes for installation which are approx. 3/4" (20mm diameter).
The 20' pole has a square base plate which is approximately 12.5" x 12.5" (320mm x 320mm).
The 20' pole is supplied with J bolts and two templates for setting the fixing bolts into new, wet concrete are included and are approx. 12.5" x 12.5" (320mm x 320mm).
The 20' pole has a bolt pattern (diagonal distance from one hole center to another) of approx. 12.75" (323mm).
The top of the 20' pole has an outside diameter of approximately 3" (76mm) and tapers outwards towards the base.
The 20' pole has a diameter of approx. 6" (150mm) at its base decreasing down to approx. 3" (76mm) at the top. - See more at: http://www.solarilluminations.com/solar-street-parking-lot-lights/sl14-solar-street-light#sthash.K2xppgCv.dpuf
The 5W model is fitted with a 7 Watt solar panel.
The 15W model is fitted with a 25 Watt solar panel.
The 20W model is iftted with a 50 Watt solar panel.
The 30W model is fitted with a 60 Watt solar panel.
The 40W model is fitted with a 60 Watt solar panel.
Short support arm and mounting bracket is included.
Easy installation onto a round column.
The clamp/bracket can be attached to a round column of 8cm (3") diameter up to 11cm (4") diameter.
Typical spacing for most models would be about every 9 metres to 15 metres (30' to 50').
The 40W model can be spaced about every 20 metres to 25 metres (60' to 75').
Can also be fitted to a square post or to a solid vertical surface such as a wall or side of a building.
The 'U' section of the clamp is removable to allow for direct surface mounting.
Service / Maintenance
Service & maintenance is entirely at the risk of the customer and/or the customer's appointed servicer/maintainer.
Please Note: This product is a special order and is non-returnable except in the event of a fault (during its warranty period) when the product, once returned will be repaired or replaced.
The solar panel must be installed in a location where it can receive full direct sunshine (when available) and set facing South at about a 45-60 degree angle (where adjustment options allow). The solar panel must not be installed in a shaded or part shaded location and never indoors. The standard specifications of the system (particularly the solar panel Wattage and battery capacity) may need to be adjusted. These components are determined by your geographic location, power consumption (LED Wattage) and the total amount of hours of illumination time required. Such changes to the standard specifications may increase or decrease the cost shown. Please contact us for more information or assistance. The illumination time is estimated and subject to various factors including (but not limited to) geographic location, seasons, temperature, weather conditions & location of product etc. The illumination time of most solar lights can reduce during winter months when the weather is poor and the days are shorter. During this time insolation hours decrease accordingly. Shorter illumination time due to one or more of the above factors does not define the product as being ‘defective’ or ‘not as described’. All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the product as being 'defective' or 'not as described'. Please note, if you do not install or use this product for several months the battery may discharge naturally on its own. By allowing a battery to deep discharge it may cause irreversible damage as the battery may then lose the ability to recharge or hold a full charge. Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice. Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
* View our Terms, Conditions and Polices (including our Returns Policy) for further information.