This contemporary solar powered wall light is fitted with several warm white LEDs that will illuminate throgh the night. The lamp automatically illuminates at dusk at 1/3 power, and switches to full brightness when motion is detected via the integrated PIR. Black powder coated finish.
The lamp emits 200 Lumens of warm white light when in full brightness. It can be used in place a broken electric light fitting, or for a new installation. It is constructed of cast aluminium with a clear polycarbonate lamp shade. The light has a built in motion sensor to activate between 1/3 brightness and full brightness mode. The solar panel is discreetly built into the top of the lampshade. The lamp will automatically activate at sunset and typically illuminate for up to 6 hours or more. Colour of light output is warm white. Colour of product is black.
This light is perfect for use around the outside of a home, on a porch or garage or possibly fixed to driveway entrance pillars or columns. It's ideal for locations where there is no electricity available or where it would be too difficult or too expensive to install electric wiring.
Light output is equal to approx. 25 Watts of incandescent lighting.
Up to 6 hours illumination at night in optimum conditions.
Available in a black powder coated finish.
Colour of light output is warm white.
Fitted with 32 LED bulbs.
Light output is 200 Lumens in full brightness.
Built-in photocell for automatic dusk-to-dawn operation.
All aluminium construction with clear polycarbonate lampshade.
Lampshade section is approximately 17.5cm x 17.5 cm x 18.5cm (7" x 7" x 7.5") LxWxD.
Complete light fitting (lampshade and light arm) stands approximately 28.5cm (11.5") high.
The wall bracket is approximately 11cm x 21.5cm (4.25" x 8.5") LxW.
The wall bracket support extends outwards to approximately 15cm (6").
The lampshade section stands approximately 7.5cm (3") off the wall surface.
2000 mA Lithium rechargeable battery included.
Life expectancy of batteries is around 3-5 years.
Integrated 1.6 Watt solar panel.
Easy to install.
Screw or bolt the arm base onto any solid level surface.
Screws & rawplugs are not included.
The solar panel must be installed in a location where it can receive full direct sunshine (when available) and set facing South at about a 45-60 degree angle (where adjustment options allow). The solar panel must not be installed in a shaded or part shaded location and never indoors. The standard specifications of the system (particularly the solar panel Wattage and battery capacity) may need to be adjusted. These components are determined by your geographic location, power consumption (LED Wattage) and the total amount of hours of illumination time required. Such changes to the standard specifications may increase or decrease the cost shown. Please contact us for more information or assistance. The illumination time is estimated and subject to various factors including (but not limited to) geographic location, seasons, temperature, weather conditions & location of product etc. The illumination time of most solar lights can reduce during winter months when the weather is poor and the days are shorter. During this time insolation hours decrease accordingly. Shorter illumination time due to one or more of the above factors does not define the product as being ‘defective’ or ‘not as described’. All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the product as being 'defective' or 'not as described'. Please note, if you do not install or use this product for several months the battery may discharge naturally on its own. By allowing a battery to deep discharge it may cause irreversible damage as the battery may then lose the ability to recharge or hold a full charge. Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice. Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
* View our Terms, Conditions and Polices (including our Returns Policy) for further information.