This solar light fitting consists of a pair of identical very large lampshade which are ideal retro-fit for an existing pole. Designed to fix directly onto an existing 76mm (3”) diameter round post, column or pole. Each lamp is fitted with 51 super bright, white LED's.
This double lampshade fitting is one of the largest solar lights of its kind and one of the most powerful too. All aluminium construction with a vandal resistant, clear polycarbonate lampshade. The solar panel is discretely built into the top of each lampshade. Each lampshade is about 64cm high, with a 36cm diameter. 51 Cree® LED bulbs are fitted inside each lampshade. The LED power is 4W+4W. The llight output is 408 Lumens per lampshade (that's equal to about 75 watts of conventional lighting per lampshade). When installed in a completely dark location the light spread can be seen for several metres around the lamp post. Colour of product is black. Colour of light output is white. Sold as a single unit.
This unique, double lampshade fitting is perfect for use in a wide variety of applications, residential, commercial, or public area use. Perfect for retro-fitting where an existing electric or gas light was in use.
Typically dusk to dawn illumination.
Automatic on at dusk and then off at dawn operation.
Discrete on/off switch for manual over-ride.
All aluminium construction.
Black coloured finish.
I.P. 65 rating.
Concave upper reflector and convex lower reflector within the lampshade housing, to enhance illumination output.
51 super bright, high output LED bulbs inside each lampshade.
Light output is 408 Lumens per lampshade (equal to about 75w of incandescent lighting per lampshade).
The lighting from the LED's shines through clear, vandal resistant, polycarbonate lampshade.
Suitable for residential and commercial applications as well as for use in public areas.
Each lampshade stands approximately 64cm (25") high (max.).
The clear polycarbonate lampshade section alone is approximately 36cm (14") diameter (at its widest (top)) and approximately 28cm (11") high.
Each lampshadeis fitted with a replaceable lithium rechargeable battery
The battery is located inside the bottom of each lampshade.
Discrete, high quality solar panel fixed flush into the top of the lampshade.
As an option, additional solar panels are available and recommended for increasing solar power (see part SP02).
The optional SP02 solar panel kit will help to increase performance and autonomy providing additional charging during in winter months and in less favourable locations
Easy to install.
Holes are pre-drilled into the round base (collar) for securing to a round post or round pole.
Screw or bolt the base onto any 76mm (3”) diameter pole.
Please Note: This product is a special order and is non-returnable except in the event of a fault (during its warranty period) when the product, once returned will be repaired or replaced.
The solar panel must be installed in a location where it can receive full direct sunshine (when available) and set facing South at about a 45-60 degree angle (where adjustment options allow). The solar panel must not be installed in a shaded or part shaded location and never indoors. The standard specifications of the system (particularly the solar panel Wattage and battery capacity) may need to be adjusted. These components are determined by your geographic location, power consumption (LED Wattage) and the total amount of hours of illumination time required. Such changes to the standard specifications may increase or decrease the cost shown. Please contact us for more information or assistance. The illumination time is estimated and subject to various factors including (but not limited to) geographic location, seasons, temperature, weather conditions & location of product etc. The illumination time of most solar lights can reduce during winter months when the weather is poor and the days are shorter. During this time insolation hours decrease accordingly. Shorter illumination time due to one or more of the above factors does not define the product as being ‘defective’ or ‘not as described’. All solar lights must be used in a completely dark location at night time otherwise they may not illuminate. Nearby strong lighting sources or ambient lighting may affect the operation of a solar light. This does not define the product as being 'defective' or 'not as described'. Please note, if you do not install or use this product for several months the battery may discharge naturally on its own. By allowing a battery to deep discharge it may cause irreversible damage as the battery may then lose the ability to recharge or hold a full charge. Although unlikely, we reserve the right to supply this product with any minor alterations or minor changes to the specifications (shown above by text description or by photographs) due to different supplies or product batches received, incorporating such product changes made by the manufacturer, without further notice. Descriptions, specifications and photographs are updated regularly but may not be current when minor changes to a product have only recently been made.
* View our Terms, Conditions and Polices (including our Returns Policy) for further information.
|Solar Lights Data|
|Lumen Output||408 lumens per lampshade|
|Equivalent Incandescent Wattage||75 watts per lampshade|
|Approximate Illumination Time||Typically dusk to dawn|
|Approximate Illumination Area||Up to about 18m diameter|